SINUS Tango Plus - Appliance; Operating Mode; Device Configuration

2 APPLIANCE
2 Appliance
2.1 Operating mode
Tango_Plus offers different operating modes:
OFF The device is off and no measurements can be performed. Only the clock is running inside.
Stop The device is running. The L
AF
and the L
CF
are measured and displayed. If Record mode is enabled,
the circle symbol is displayed.
NOTICE! The time between STOP and a possible new measurement is: 16 ms.
Run The device is on and measuring ( is blinking). If data recording has been activated, data will be
stored ( is blinking). You may read the instantaneous measurement values on the display and move
between the values using the Up/Down keys.
Pause A running measurement is paused ( is displayed) and so the measuring time. The measurement
can be stopped or proceeded any time.
Repeat If a duration is specified and repeat mode enabled, the so configured measuremet is repeated in
the specified interval.
Start Time A measurement is configured, but waiting with record for the specified time ( is blinking). The
device can be shut down. It will wake up automatically to perform the measurement and shut down
afterwards again. The measurement can be stopped any time.
Display Description
The device is in Pause-Mode. The measurement has been paused and the measuring time has been stopped.
Data recording is active. The measured data will be stored in Run-Mode.
The device is in Run-Mode (Symbol blinks). The measurement has been started. If data recording is active, the
measured data are stored. If data recording is inactive, no data will be stored.
A measurement is configured, but waiting with record for the specified time (symbol is blinking). When the measure-
ment is running, the symbol stops blinking.
Table 2.1: Display of run modes
NOTICE! The setting for automatic start time can only be configured manually on the
device.
2.2 Device configuration
You may configure the device manually or via PC using the software Tango-Utilities.
2.2.1 Manual configuration
The manual configuration of the device without PC is shown in the following table 2.2:
Manual Tango_Plus 12 of 47 SINUS Messtechnik GmbH