8
-Check with a qualified electrician if you do not understand grounding instructions or if you are in doubt as to whether the
tool is properly grounded.
-This tool is equipped with an approved cord and a 3-prong grounding type plug for you protection against shock hazards.
-Grounding plug should be plugged directly into a properly installed and grounded 3-prong grounding-type receptacle, as
shown.
-Do not remove or alter grounding prong in any manner. In the event of a malfunction or breakdown, grounding provides a
path of least resistance for electrical shock.
WARNING: This machine is for indoor use only. Do not expose to rain or use in damp locations.
SUPPLEMENTARY SAFETY INSTRUCTIONS
1 Regularly check that blades and lock bars are locked tight in cutter block.
2 Max. allow able blade projection over cutter block 1.0mm/0.004 inch +10%.
3 Never remove any of the machine’s safety guards other than for servicing and repair work. Keep
guards operational at all times.
4 Set and secure safety guards in position before operating machine.
5 This machine must be safety earthed. The yellow/green (green) lead is the earth conductor.
6 Regularly check anti-kickback fingers for proper operation.
7 Always wear eye protection.
8 Rebating, tenoning , moulding and recessing may not be undertaken without the use of special
guards
9 Never make jointing or planning cut deeper than 2 mm
USER RESPONSIBILITY
This machine will perform in conformity with the description contained in this manual when installed,
operated, maintained and repaired in accordance with the instructions provided.
This machine must be checked periodically. Defective equipment (including power cable) should not be
used. Parts that are broken, missing, plainly worn, distorted or contaminated, should be replaced
immediately. Should such repair or replacement become necessary, it is recommended that such repairs
be carried out by qualified persons.
This machine or any of its parts should not be altered or changed or changed from standard
specifications. The user of this machine shall have the sole responsibility for any malfunction which results
from improper use or unauthorized modification from standard specification, Faulty maintenance,
damage or improper repair.
To Next Page
Loading...