8
Note: Always make sure the mains supply is of the correct voltage and the
correct fuse protection is used. In the event of replacing the fuse always
replace the fuse with the same value as the original.
Warning: Never connect live or neutral wires to the earth terminal of the plug. Only
fit an approved plug with the correct rated fuse. If in doubt consult a qualified elec-
trician.
GUARANTEE
Note: Proof of purchase will be required before any warranty can be hon-
oured.
Note: If an extension lead is required in order to reach the mains supply;
ensure that this too is rated for the correct voltage and fuse rating.
Note: The cross section of the extension lead should be checked so that it is
of sufficient size so as to reduce the chances of voltage drops.
ELECTRICAL CONNECTION….cont
Guarantee:
This SIP belt / disc sander is covered by a 12 month parts and labour warranty, cover-
ing failure due to manufacturers defects. This does not cover failure due to misuse or
operating the sander outside the scope of this manual - any claims deemed to be
outside the scope of the warranty may be subject to charges including, but not lim-
ited to parts, labour and carriage costs. Consumable items such as fuses, sanding
belts and discs are not covered by the warranty.
In the unlikely event of warranty claims, contact your distributor as soon as possible.
Proof of purchase will be required before any warranty can be honoured.
To Next Page
Loading...
General