4
SAFETY SYMBOLS USED THROUGHOUT THIS MANUAL
SAFETY INSTRUCTIONS
IMPORTANT: Please read the following instructions carefully, failure to do
so could lead to serious personal injury and / or damage to the plas-
ma cutter.
Danger / Caution: Indicates risk of personal injury and/or the possibility of
damage.
Warning: Risk of electrical injury or damage!
Note: Supplementary information.
When using your inverter plasma cutter, basic safety precautions should always be
followed to reduce the risk of personal injury and / or damage to the plasma cutter.
Read all of these instructions before operating the plasma cutter and save this user
manual for future reference.
The plasma cutter should not be modified or used for any application other than that
for which it was designed.
This plasma cutter was designed to cut electrically conductive materials such as mild
steel.
If you are unsure of its relative applications do not hesitate to contact us and we will
be more than happy to advise you.
Before each use of the plasma cutter always check no parts are broken and that no
parts are missing.
Always operate the plasma cutter safely and correctly.
KNOW YOUR PLASMA CUTTER: Read and understand the owner's manual and labels
affixed to the plasma cutter. Learn its applications and limitations, as well as the po-
tential hazards specific to it.
KEEP WORK AREA CLEAN AND WELL LIT: Cluttered work benches and dark areas invite
accidents. Floors must not be slippery due to oil, water or sawdust etc.
DO NOT USE THE PLASMA CUTTER IN DANGEROUS ENVIRONMENTS: Do not use the
plasma cutter in damp or wet locations, or expose it to rain. Provide adequate space
surrounding the work area. Do not use in environments with a potentially explosive at-
mosphere.
To Next Page
Loading...
