SIP SILO 80 D User Manual

27
ROKOVANJE Z IZMETALNO
CEVJO
(slika 6, 7 in 8)
Obračanje izmetalne cevi je izvedeno z
enostransko delujočim hidravličnim valjem.
Traktor mora imeti hidravlično opremo,
izvedeno z ventilom in ustrezno hitro spojko.
Ustrezni položaj cevi si izberite z zamikom
ročice valja in namestitvijo vijaka »A«
(slika 8) v ustrezno izvrtino na opori
spodnjega dela cevi.
EJECTING TUBE STEERING
(Fig. 6, 7 and 8)
Turning of the ejecting tube is performed by
one-way acting hydraulic cylinder. The tractor
must have the hydraulic equipment with valve
and adequate quick clamp.
Choose the suitable position of the ejecting
tube by moving the valve crank and by
placing the screw »A« (fig. 8) into different
holes on the lower part of the tube.
Fig. 6, 7
Fig. 8
Če silirate s priključeno prikolico za strojem,
montirajte ročico »F« v izvrtino segmenta
»A« (slika 6), če pa silirate z vzporedno vleko
prikolice (slika 7), montirajte ročico »F« v
izvrtino »B«.
Pri transportu ter deponiranju stroja lahko
izmetalno cev spustite ter tako zmanjšate
višino stroja. Na posebno zahtevo dobavimo
elemente za obračanje izmetalne cevi z
vlečno potisnim bovdenom, s pomočjo
katerega voznik traktorja obrača izmetalno
cev in nagiba loputo iz kabine traktorja preko
ročic na komandni plošči.
When ensilaging with the wagon attached
behind the machine set the crank »F« in the
hole of plate »A« (fig. 6). When ensilaging
with the wagon parallel to the machine set
the crank »F« in the hole »B«.
When transporting and storing the machine
you can lower the ejecting tube to reduce the
height of the machine. On special demand
we can equip the machine with the parts for
turning the ejecting tube by directing wire.
This way the driver can easily steer the
ejecting tube from the tractor cabin using the
cranks on the command plate.
A
B
A
F

SIP SILO 80 D Specifications

General

Brand	SIP
Model	SILO 80 D
Category	Farm Equipment
Language	English