SIP T136 User Manual

14
CONTENTS AND ACCESSORIES
Note: If any of the above are missing or damaged, contact your distributor
immediately.
Ref. No. Description
A. MIG Welder
B. Handle & Fixings
C. Face Mask
D. Gasless Wire
E Mig Tips
F. Bottle Bracket (69mm T136 and T166 only)
G. Bottle Bracket (74mm T136 and T166 only)
H. Gas Hose And Clips (T136 and T166 only)
I. Manual
B
F
G
H
E
A
C
D
I
23
MAINTENANCE
If the fault light illuminates you should contact your distributor, or SIP directly to
have the welder checked / repaired.
Clear dust from the machine at regular intervals, if used in a dirty environment
the machine should be cleaned once a month.
Check all connections are clean and tight, if there is any oxidization clean the
connection with a mild abrasive or wire brush.
Check all cable for damaged or degradation to the insulation, replace if any
found.
Check earth clamp condition ensure they clamp tightly, replace if damaged or
loose.
If the machine is not to be used for a long time, store it in the original packing a
dry place.
The mig tip and shroud must be cleaned frequently to removes spatter.
Replace the mig tip regularly, good electrical contact between the tip and wire
is essential.
The torch liner should be blown through with dry compressed air from time to
time, if the wire does not pass freely through the liner it should be replaced.

SIP T136 Specifications

General

Brand	SIP
Model	T136
Category	Welding System
Language	English