1.
.
2.
, .
3.
, 3000
4.
, .
Pre-start checks.
1.
The machine shall not be started running until the completion of oiling.
2.
The rotating direction of the balance whell, when the maching is started running,shall
be in counter-clockwise one.(View from the right side of the balance wheel.) A warning shall be
given in advance against making the machine run while balance wheel turning clockwise.
3.
The machine shall be under operation at less than 3,000 s.p.m. for the first month.
4.
Check power source, voltage.and phase number to see whether they are in accordance
with the ratings on the name plate of the motor to be used.
1.
, .
2.
, .
3.
, .
4.
, , , ,
.
5.
, ,"V"
6.
, .
Operating instructions
1.
Do not put your hands under the lower part of the needle when the machine is running.
2.
Do not put your fingers into the thread take-up lever cover when the machine is running.
3.
Only when the machine stops can you turn the balance wheel by hand.
4.
After the motor switch being turned off , due to inertia , the machine tilted unless it
stops.
5.
Keep away from the balance wheel, V-belt, winder and the motor.
6.
Do not start running the machine during mounting or relacing the belt cover. finger
guard etc.
. 3 .
To Next Page
Loading...
Need help?
General
