Siruba DL918 - Page 11

G 11
with few ms interruption at end
of each seam. The interruption
time set by “027” timer.
13
起始回缝結束點操作
模式
Mode Selection at the
End of Start Tacking
CON/STP CON
CON:
執行完起始回缝段針數
後，即自動連續執行下一段的
功能設定。
CON: At the end of start
tacking, it continues operations
if foot pedal presses.
STP: 執行完起始回缝段針數
後，必須再次前踏後始恢復一
般功能。
STP: At the end of start tacking,
the re-start must be controlled
by foot pedal forward treading.
14
起始回缝功能
Start Tacking Function
Selection
ON/OFF ON
15
起始回缝
A
段車縫針數
Stitch A Setting for Start
Tacking
0~15 3
16
起始回缝
B
段車縫針數
Stitch B Setting for Start
Tacking
0~15 3
17
起始回缝回數
Turns Setting for Start
Tacking
0~4 3
18
起始回缝
A
段針數補償
Stitch A Balance for
Start Tacking
00~0F 0
19
起始回缝
B
段針數補償
Stitch B Balance for
Start Tacking
00~0F 0
20
終止回缝模式
Mode Selection for End
Tacking
A/SU/SD A
A:
車缝後觸動全後踏功能，即
自動執行完終止回缝段針數。
A: One shot sewing.
SU: 於各段轉角處自動暫停針
上後，始繼續執行下一段針
數，暫停時間由參數"027"調整
控制。
SU: One shot sewing while
motor stops at needle UP with