Siruba DL918 - Page 12

G 12
few ms interruption at end of
each seam. The interruption
time set by “027” timer.
SD: 於各段轉角處自動暫停針
下後，始繼續執行下一段針
數，暫停時間由參數"027"調整
控制。
SD: One shot sewing while
motor stops at needle DOWN
with few ms interruption at end
of each seam. The interruption
time set by “027” timer.
21
終止回缝功能
End Tacking Function
Selection
ON/OFF ON
22
終止回缝
C
段車縫針數
Stitch C Setting for End
Tacking
0~15 3
23
終止回缝
D
段車縫針數
Stitch D Setting for End
Tacking
0~15 3
24
終止回缝回數
Turns Setting for End
Tacking
0~4 2
25
終止回缝
C
段針數補償
Stitch C Balance for End
Tacking
00~0F 0
26
終止回缝
D
段段針數補
償
Stitch D Balance for End
Tacking
00~0F 0
27
自動回缝段落停止時
間
Interruption Time
Setting at Section End
of Tacking
0~999 50
單位 (Unit): ms
28
起始
/
終止回缝針數設
定
Stitch Setting for Start /
End Tacking
ON/OFF OFF
ON:
有效
ON: The function is Valid.
OFF:無效
OFF: The function is invalid.
29
起始
/
終止回缝針數補
0~99 0
當執行起始或終止回缝功能