Siruba DL918 User Manual

G 34
錯誤碼
Error
Code
異常現象說明
Cause of the Problem
解決措施
Measurement and Solution
Err 21
Hall sensor
異常
Hall Sensor Abnormal
1. 關閉電源。
Turn off the power.
2.
檢查電機編碼器連接線
(CN701)
是否接觸不良或馬達編
碼器是否故障。
Check the connection between motor encoder and control
box or (CN701) if any malfunction on motor encoder board.
3.
排除後重新送電，若仍無法正常運轉，請通知廠商。
Turn on the power again. If the machine still cannot operate
normally, please contact with qualified technician.
安全開關檢知遮斷
Safety Switch Error
一般模式下，旋轉符號不轉動時:
When the motor rotating symbol stops during Normal Mode:
1.
關閉電源，檢查縫紉機安全開關
(CN706)
是否故障。
Turn off the power and check the connection for safety
switch (CN706).
2. .
排除後重新送電，若仍無法正常運轉，請通知廠商。
Turn on the power again. If the machine still cannot operate
normally, please contact with qualified technician.

Siruba DL918 Specifications

General

Brand	Siruba
Model	DL918
Category	Sewing Machine
Language	English