IMPORTANT SAFETY INSTRUCTIONS
To
get the most out
of
the many functions
of
this machine and operate it
in
safety, it is necessary to use this
machine
correctly.
Please
read this Instruction Manual carefully before use. We hope you will enjoy the use
of
your machine
for a long time.
Please remember to keep this manual
in
a safe place.
1.
Observe the basic safety measures, including, but not limited to the following ones, whenever you use the
machine.
2.
Read all the instructions, including, but not limited to this Instruction Manual before you use the
machine,
In
addition, keep this instruction Manual so that you may read it at anytime when necessary.
3.
Use the machine after it has been ascertained that it conforms with safety rules/standards valid
in
your
country.
4.
All safety devices must be
in
position when the machine is redady for work or
in
operation. The operation
without the specified safety devices is not
allowed.
5.
This machine shall be operated by appropriately-trained operators.
6.
For your personal protection, we recommend that you wear safety glasses.
7.
For the following, turn off the power switch of disconnect the power plug of the machine from the receptacie.
7.1
For threading needle (s) and replacing bobbin.
7.2 For
replacing part (s) of needle, presser foot, throat plate, feed dog, cloth gude etc.
7.3 For repair work.
7.4 When
leaving the working place
of
when the working place
is
unattended.
8.
If you should allow oil, grease, etc. used with the machine and devices to come
in
contact with your eyes
or skin or
swallow any of such liquid
by
mistake, immediately wash the contacted areas and consult a
medical doctor.
9.
Tampering with the live parts and devices. regardless
of
whether the machine
is
powered, is prohibited.
1
0.
Repair, remodeling and adjustment works must only
be
done
by
appropriately trained technicians or
specially skilled personnel.
11. General maintenance and inspection works have to be done
by
appropriately trained personel.
12. Repair and maintenance works
of
electrical components shall be conducted
by
qualified electric
technicians or under the audit and guidance of specially skilled personnel.
Whenever you find a failure
of
any of electrical components, immediately stop the machine.
13.
Periodically clean the machine throughout the period of use.
14. Grounding the machine
is
always necessary fot the normal operation of the machine. The machine has
to be operated
in
an envivronment that
is
free from strong noise sources such as high-frequency welder.
15.
An
appropriate power plug has to be attached to the machine
by
electric technicians, Power plug has to
be connected to a grounded
receptacle.
16. The machine
is
only allowed to be used for the purpese intended. Other used are not allowed.
17. Remodel or modify the machine
in
accordance with the safety rules/standards while taking
all
the effective
safety measures. We assumes
no
responsibility for damage caused
by
remodeling or modification
of
the
machine.
18. Warning hints are marked with the two shown
symbols.
A Danger
of
injury to operator
or
service staft
& Items requiring special attention
-11-
To Next Page
Loading...
Need help?
General
