FOR SAFE OPERATION
Lt
1.
To
avoid electrical shock hazards, neither open the cover
of
the electrical box for the
motor nor touch the components mounted inside the
electrical box.
1.
To
avoid personal injury, never operate the machine with any of the belt cover, finger
guard
of
safety daevices removed.
2.
To
prevent possible personal injuries caused by being caught
in
the machine. keep
&
your fingers, head and clothes away from the handwheel, V belt and the motor while
the machine
is
operation.
In
addition, place nothing around them.
3.
To
avoid personal injury, never put your hand under the needle when you turn "ON"
the power switch or operate the machine.
4.
To
avoid personal injury, never put your fingers into the thread take-up cover while
the machine
is
in
operation.
5.
The looper rotates at a high speed while the machine
is
in
operation,
To
prevent poss-
ible injury to hands, be sure to keep your hands away from the vicinity of the looper
during operation.ln addition, be sure to turn OFF the power to the machine when
replacing the looper.
6.
To
avoid possible personal injuries, be careful not to allow your fingers in the ma-
chine when tiling/raising the machine head.
7.
To
avoid possible accidents because
of
abrupt start
of
the machine, turn OFF the
power to the machine when
tilting the machine head or removing the belt cover and
the V
belt.
8.
If your machine
is
equipped with a servo-motor, the motor does not produce noise
while the machine is at rest.
To
avoid possible accidents due to abrupt start of the
machine,
be
sure to turn OFF the power to the machine.
9.
To
avoid electrical shock hazards, never operate the sewing machine with the ground
wire for the power
supply removed.
10.
To
prevent possible accidents because of electric shock or damaged electrial compo-
nent(s), turn
OFF the power switch in prior to the connectrion/disconnecti
on
of
the
power
plug.
-IV-
To Next Page
Loading...
Need help?
General
