This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 20/3 - Last updating 10/2019
TS-One Manual for use and maintenance
40
4.3 Electrical Requirements
Ensure the electrical system in the installation premises complies with the safety standards in
force. The system and the power cord must be adequate for the power installed.
values on the plate and in this manual 2.4.
The machine can be connected to the ground distribution system used in the intended country
For electrical connections, it is good practice to abide by installation rules for the preparation
be installed protected by a type A differential switch dimensioned for the
voltage values and the differential current not exceeding 30mA;
current intervention under 16A and shut-off power equal at least to the fault current in the
installation point.
The intervention curve of the differential switch is outlined below.
The effects are normally not perceived.
The harmful effects from a medical point of view are normally not yet present.
TS
ONE
4
EN
10000
10 mA 30 mA
2000
1000
500
200
100
50
20
0,1 0,2 0,5 12 5102050 100 200 500 1000 10000mA
ms
I
:
To Next Page
Loading...
