To Next PageTo Next PageWhat to do if SKF Switch desk switch does not operate?
If the SKF Switch desk switch isn't working, the issue might stem from a poor plug-in connection. To resolve this, check the plug-in connections to ensure they are properly connected.
Owner/operator liable for function if improperly maintained/repaired or used outside specified application.
Used to operate one, two, or a maximum of three linear actuators with pushbuttons on the front panel.
Consists of the desk switch and the connecting cable.
Actuator is set in motion by pressing a button and continues until released.
Units must not be operated in potentially explosive environments, exposed to moisture, or used outdoors.
Attach using four mounting holes; ensure cables are secured to prevent force on connectors.
Connect desk switch cable to appropriate control unit, locking device, or actuator.
Details on memory operation principle for actuators, including position storage and recall.
Diagram and instructions for setting and calling up memory positions for actuators.
Steps to move actuators to basic position and store positions 1, 2, and 3 using the 'M' and number buttons.
Press appropriate position button (1, 2, or 3) to move actuators to stored positions.
Clean with damp cloth and isopropyl alcohol; avoid moisture and chemical additives.
Examine housing and cables for mechanical damage periodically; replace if damaged.
Addresses issues like desk switch not operating, primarily checking connections.
Specifies operating and storage temperature and humidity ranges for the desk switch.
General