What to do if SKF TIH 030M shows electronics communication problem (E10E)?
If the SKF Electric Heater displays an electronics communication problem (E10E), first, try switching the heater OFF and then back ON. If the problem persists, the TIH should be returned to SKF for repair.
What to do if SKF Electric Heater shows electronics communication problem (E11E)?
If the SKF Electric Heater displays an electronics communication problem (E11E), first, try switching the heater OFF and then back ON. If the problem persists, the TIH should be returned to SKF for repair.
What to do if SKF TIH 030M shows electronics communication problem (E12E)?
If the SKF Electric Heater displays an electronics communication problem (E12E), first, try switching the heater OFF and then back ON. If the problem persists, the TIH should be returned to SKF for repair.
What to do if there is an electronics communication problem with SKF Power Tool?
If you're experiencing an electronics communication problem with your SKF Power Tool, try switching the heater off and then back on. If the problem persists, the TIH should be returned to SKF for repair.
How to fix an overheated coil in SKF Power Tool?
If your SKF Power Tool's coil is overheated, wait for the inductive coil to cool down. Then, switch the heater off and then back on.
What to do if temperature of SKF Power Tool increases less than 1°C every 15 seconds?
If the temperature increase is less than 1°C (1.8°F) every 15 seconds (or 1° every 30 seconds), check the temperature probe connection. If the connection is okay, select the 30-second interval as described in section 6, or operate the heater in TIME MODE.
What to do if the SKF TIH 030M coil overheats?
If the inductive coil of your SKF Electric Heater overheats, allow it to cool down. Then, switch the heater OFF and then back ON.
What to do if temperature increase of SKF TIH 030M is less than 1°C every 15 seconds?
If the temperature increase is less than 1°C (1.8°F) every 15 seconds (or 1° every 30 seconds), check the temperature probe connection. If the connection is OK, select the 30 second interval or operate the SKF Electric Heater in TIME MODE.
Describes the primary purpose and applications of the induction heater.
Explains the magnetic induction process used to generate heat in the workpiece.
Highlights key features like remote control, inductive coil design, and yoke storage.
Lists and describes the main parts of the induction heater, including the core, coil, and accessories.
Provides detailed specifications for voltage, power, temperature control, dimensions, and weight.
Explains the meaning of the indicators on the remote control display and power LEDs.
Describes the purpose and action of each button on the remote control panel.
Details how to use the TEMP MODE for setting and controlling target temperatures.
Explains how to use the TIME MODE for setting and controlling heating duration.
Describes how to measure the workpiece temperature when the heater is not operating.
Explains how to switch between Celsius (°C) and Fahrenheit (°F) temperature units.
Explains the automatic demagnetization process and how to use it for manual demagnetization.
Provides guidelines for selecting the appropriate power level based on workpiece sensitivity and yoke size.
General| Frequency | 50-60 Hz |
|---|---|
| Maximum Bearing Weight | 40 kg |
| Maximum Bearing Diameter | 300 mm |
| Temperature Control | Yes |
| Magnetic Temperature Probe | Yes |
| Demagnetization | Automatic |
| Housing Material | Steel |
| Voltage | 230 V |
| Operating Temperature Range | 0-40 °C |
To Next Page
