12
SKF TKRT 20
4. Maintenance
Important:
Repair or servicing should only be carried out by SKF.
1. The TKRT 20 is not intended to be exposed to dusty conditions.
2. If excessive wear/corrosion has taken place to the plating on
the housing and another colour begins to show through,
the unit must be returned to SKF for attention.
3. The TKRT 20 should not be subjected to mechanical or thermal stress,
nor should it be subjected to any aggressive substances.
Note:
This instrument has been designed such that it will not give rise to
injury or other harm due to contact, nor will it produce excessive heat,
infrared, electromagnetic or ionising radiation, nor does it have any
non-electrical dangers.
5. Spare parts and accessories
Designation Description
TMRT 1-56 Laser remote sensor
TMRT 1-57 Contact adapter
TMRT 1-57K Tyre and RPM cone set
TMRT 1-59 Reflective tape
TMRT 1-60 Bracket for laser remote sensor
TDTC 1/A General toolcase without inlay, size A
To Next Page
Loading...
