30
To prime, activate button until a pumping resistance is felt. From this
point, pump 2 or 3 times to inject fuel in intake manifold. After prim-
ing, ensure that primer button is pushed back.
NOTE : In very cold temperature, it is recommended to rotate
primer button 3-4 turns prior to pull it. This will eliminate the
possibility of sticking.
11) Choke lever
This device features a 3-position lever to facilitate cold start.
1. OFF
2. Position 1
3. Position 2
Initial Cold Starting
NOTE : Do not operate the throttle lever with the choke lever
on.
Move the choke lever to position 2 and start the engine. As soon as
the engine starts move the lever to position 1. After a few seconds
(10 seconds maximum) move the choke lever to OFF.
NOTE : In severe cold weather, colder than -20°C (-4°F) you
may need to turn the choke on and off a couple of times to
position 1 once engine is started.
Warm Engine Starting
Start the engine without any choke. If the engine will not start after
two pulls of the rope or two 5 second attempts with the electric
starter move choke lever to position 1. Start the engine without acti-
vating the throttle lever. As soon as the engine starts move the
choke lever to OFF.
1
2
3
A06H1KA
To Next Page