26
5) Ignition Switch
The lights are automatically ON whenever the engine is running.
MANUAL START ELECTRIC START
1. OFF 1. OFF
2. ON 2. ON
3. START
Manual Starting
Key operated, 2-position switch. To start the engine, first turn the key
to ON position. To stop the engine, turn the key to OFF position.
Electric Starting
Key operated, 3-position switch. To start engine, turn key to START
position and hold. See illustration above.
Release key immediately when engine has started. Key returns to
ON position as soon as it is released.
If engine does not start on first try, key must be turned fully back to
OFF each time. To stop engine, turn key to OFF position.
NOTE :Engine may be manually started with rewind starter if
necessary.
If starter does not operate, check starting system fuse condition.
Refer to starting system fuse below.
-
CAUTION
Do not hold key at START position more than 30 seconds. A
rest period should be observed between the cranking cycles
to let starter cool down. Holding key in START position when
engine has started could damage starter mechanism.
1 1
2
2
3
A23H04A
To Next Page