97
To adjust tension:
– Loosen the rear idler wheel retaining screws.
– Loosen the lock nuts (on some models only) then turn adjustment
screws to adjust.
If correct tension is unattainable, contact an authorized dealer.
TYPICAL
1. Adjustment screw
2. Loosen lock nut (some models only)
3. Loosen screw
Alignment
NOTE : Track tension and alignment are inter-related. Do not
adjust one without the other.
-
CAUTION
Too much tension will result in power loss and excessive
stresses on suspension components.
◆
WARNING
Before checking track alignment, ensure that the track is free
of all particles which could be thrown out while track is rotat-
ing. Keep hands, tools, feet and clothing clear of track. Ensure
no one is standing in close proximity to the snowmobile.
1
2
3
A05F0EA
To Next Page