Section 08 BODY/FRAME
Sub-Section 02 (BODY)
08-02-4
PLASTIC MAINTENANCE AND REPAIR
MAINTENANCE
Clean the vehicle thoroughly, removing all dirt and
grease accumulation.
To clean use a soft clean cloth and either soapy
water or isopropyl alcohol.
To remove grease, oil or glue use isopropyl alco-
hol.
– gasoline
– brake fluid
– kerosene
– diesel fuel
– lighter fluid
– varsol
– naphtha
– acetone
– strong detergents
– abrasive cleaners
– waxes containing an abrasive or a cleaning
agent in their formula
Apply wax on glossy finish only. Protect the vehi-
cle with a cover to prevent dust accumulation dur-
ing storage.
-
CAUTION
Do not apply isopropyl alcohol or acetone
directly on decals.
-
CAUTION
The following products must not be used to
clean or wax any of the plastic components
used on the vehicles:
-
CAUTION
Clean R.I.M. Metton
®
with isopropyl alcohol
only. Never use cleaners or products con-
taining chlorine.
-
CAUTION
If for some reason the snowmobile has to be
stored outside it is preferable to cover it with
an opaque tarpaulin. This will prevent the
sun rays from affecting the plastic compo-
nents and the vehicle finish.
To Next Page
Loading...
Need help?
General
