- Refill tank slowly until coolant over-
fills at bleed hole.
Reinstall bleed screw.
536
Engine
Type
Continue to pour the coolant
in
the tank
until level reaches
60
mm
(2
3/8
in) be-
low top of radiator (engine cold).
With the coolant tank cap still remov-
ed
start the engine and let it warm up
to reach its operating temperature and
open thermostat.
Run
a few minutes
more.
Stop engine and check coolant freez-
ing point with a suitable tester. Freez-
ing point must
be
low enough for the
temperatures at which the vehicle will
be
operated.
Check
level
and add coolant if required.
Install coolant tank
cap.
.A.
WARNING: Before removing the
T cap place a cloth over the cool-
ant tank and release the cap to the
first step to release the pressure.
Loss
of fluid and severe burns could occur
if this notice
is
disregarded.
Engine Lubrication
Engine internal parts must
be
lubricat-
ed
to protect them from possible rust
formation during the storage period.
To
perform the storage procedures pro-
ceed
as
follows:
1.
Lift the rear
of
the vehicle and sup-
port it
off
the ground .
.A.
WARNING: Ensure the track
is
T free of
ails
particles which could
be
thrown out while it
is
rotating. Keep
hands, tools, feet and clothing clear
of track. Ensure no one
is
standing
in
close proximity to the vehicle.
2.
Start the engine and allow it to run
at idle speed until the engine reaches
its operating temperature.
3.
Stop the engine.
4.
To
prevent gasoline from draining,
primer button should
be
pushed all
the way in.
5.
Disconnect
the
outlet primer
hose
from
the primer
valve.
43
To Next Page
Loading...
