Chassis
Clean the vehicle thoroughly, removing
all dirt and grease accumulation.
,.,
CAUTION: Plastic alloy com po-
T nents such
as
fuel tank, wind-
shield, controls, etc., can
be
cleaned
using mild detergents or isopropyl al-
cohol and a soft clean cloth. Never
clean plastic parts with strong deter-
gent, degreasing agent, paint thinner,
acetone, etc. Never clean RIM Metton
hood with cleaners or products con-
taining chlorine. Do not apply isopro-
pyl
alcohol directly
on
decals.
Inspect the hood and repair any dam-
age.
Clean the frame.
For
the unpaint-
ed
aluminum portion use only
''Alumi-
num cleaner'' and follow instructions
on
the container.
Touch up
all
metal spots where paint
has been scratched off. Spray all metal
parts with metal protector. Wax the hood
and the painted portion
of
the frame for
better protection.
0
NOTE: Apply wax on glossy fin-
ish only. Protect the vehicle with
a cover to prevent dust accumulation
during storage.
,.,
CAUTION: If snowmobile has to
T
be
stored outside it
is
necessary
to cover it with
an
opaque tarpaulin.
This will prevent
sun
rays and grime
from affecting plastic components
and vehicle finish.
General
Inspection
Check the electrical wiring and com-
ponents, retighten loose connections.
Check for stripped wires or damaged
insulation.
Thoroughly inspect the vehicle and tight-
en
loose bolts, nuts and linkage.
0
NOTE:
Leave
drive belt off the pul-
leys for entire storage period.
45
To Next Page
Loading...
