Release the key as soon as the engine
starts. Key returns to ON position as
soon as it is released.
If the engine does not start on the first
try, turn the key back to OFF and wait
a few seconds before restarting. To
stop engine, turn the key to OFF.
NOTE:
Engine may be manually start-
ed with rewind starter if necessary.
If starter does not operate, check start-
ing system fuse condition. Refer to
STARTING SYSTEM AND ELECTRIC
POWER OUTLET FUSE.
Expedition TUV Series
To start engine, push START button
and hold until engine has started.
CAUTION: Do not hold START but-
ton more than 10 seconds. A rest
period should be observed be-
tween the cranking cycles to let
starter cool down. Holding START
button when engine has started
could damage starter mechanism.
Release START button immediately
when engine has started.
If engine does not start on first try,
wait a few seconds then repeat proce-
dure. To stop engine, turn off engine
cut-out switch or pull off tether cord
cap.
10)Tether Cut-Out Switch
General
When the tether cord cap is removed,
its shuts the engine off preventing
snowmobile to runaway if the opera-
tor falls off the vehicle accidently.
WARNING
Always remove tether cord cap
and key when vehicle is not in
operation in order to prevent ac-
cidental engine starting, to avoid
unauthorized use by children or
others or theft.
Operation
Attach tether cord eyelet to clothing,
then snap tether cord cap over post
before starting engine.
A06H1YA
2
1
TYPICAL
1. Snap over post
2. Attach to eyelet
If emergency engine shut off is re-
quired, completely pull tether cord cap
from post.
®
A06H1XA
TYPICAL
DESS (Digitally Encoded
Security System) Key/Cut-Out
Switch
Liquid Cooled Models
On these models, the tether cord cap
is digitally encoded to provide you
and your snowmobile with the equiv-
alent security of a conventional lock
keyanditsshutsofftheenginepre-
venting snowmobile to runaway if the
operator falls off the vehicle accident-
ly.
42
______________________
To Next Page
Loading...
Need help?
General
