17
when using screw-driver bits G, additionally
use the universal bit holder H.
§ Do not use bits with a damaged shank.
Starting operation
ON/OFF SWITCH (see figure 3)
To start the machine, press the On/Off
switch C and keep it depressed and to
switch off the machine, release the On/Off
switch C.
Attention: If the rotational direction switch B
to the centre position is not possible press
the On/Off switch C.
REVERSING THE ROTATIONAL
DIRECTION
§ Operate the rotational direction switch
B only at a standstill.
The rotational direction switch B is used to
reverse the rotational direction of the
machine. However, this is not possible with
the On/Off switch C actuated.
Right Rotation: Press the rotational
direction switch through (normal operation:
drilling, screwdriving, etc.).
Left Rotation: Press the rotational direction
switch through (for loosening and
unscrewing screws and nuts).
When not properly set in left/right
position, switch C can not be activated.
Application device
Use the appropriate bits.
! Do not use damaged bits.
When turning in a screw at/near the cross
cut end or an edge of wood one should pre-
drill a hole in order to avoid cracking of the
wood
For an optimal use of the tool a steady
pressure on the screw is required, especially
while removing
When screwdriving in hard wood one should
pre-drill a hole
Maintenance
§ Unplug charger from power source
before cleaning.
For safe and proper working, always keep
the machine and the ventilation slots clean.
Keep tool and charger clean.
- The charger may be cleaned most
effectively with compressed air (wear
safety goggles).
- Clean charging contacts in charger with
alcohol or contact cleaner.
If the machine should fail despite the
rigorous manufacturing and testing
procedures, repair should be carried out by
an authorized customer services center for
SKIL Power Tools
Guarantee
We guarantee SKIL appliances in
accordance with
Statutory/country-specific regulations (proof
of purchase by invoice or delivery note).
Damage attributable to normal wear and
tear, overload or improper handling will be
excluded from the guarantee.
In case of complaint please send the
machine, undismantled, to your dealer or
the SKIL Service Center for Electric Power
Tools.
Warning! Freight and insurance costs are
charged to the client, even for warranty
claims.
Environmental protection
Recycle raw materials instead of
disposing as waste.
The machine, accessories and packaging
should be sorted for environmental-friendly
recycling.
The plastic components are labeled for
categorized recycling.
The nickel-cadmium battery must be kept
separate from the natural environment and
should not be disposed of as normal
domestic. Do not use tool or charger when
damaged; take it to one of the officially
registered SKIL
Service Stations for a safety check.
Subject to change without notice
To Next Page
Loading...
Need help?
General
