16
WHEN CONNECTING NEW 3-PIN PLUG
§ Do not connect the blue (= neutral) or
brown (= live) wire the cord of the charger
to the earth terminal of the plug.
§ If for any reason the old plug is cut off the
cord of the charger, it must be disposed
of safely and not left unattended.
Introduction
This tool with left/right rotation is intended
for screwdriving in wood.
This tool must be used to screw and to
unscrew, does not have to be used as the
“key of the squeeze” therefore such use can
reduce the life utility of the product.
This machine is restricted to the domestic
use, no being indicated for professional
works.
Read and save this instruction manual
Tool Specifications
Cordless screwndriver SKIL 2000
Type N° F 012 200 0..
Rated Voltage [V] 3,6
No-load speed [min-1] 200
Screw diametes
∅ máx. [mm] 13 (1/2”)
Chame time
F 000 624 017 / 018 [h] 3 -5
F 000 624 016 / 019 [h] 5-7
Collety capacity [mm] 6,35 (1/4”)
Weight [kg] 0,34
Machine Elements
A Holder
B Forward/reverse function
C On/Off switch
D Charger output plug
E Charger
F Plug on the charger
G Bits*
H Bit Holder*
* The accessories illustrated or described
are not included as standard delivery.
Before Putting into Operation
BATTERY CHARGING
Battery of new tools is not fully charged.
A battery that is new or has not been used
for a longer period does not develop its full
capacity until after approximately 5
charging/discharging cycles.
Plug the output cord of the charger E into
the socket in the bottom of the screwdriver
handle plug the charger D into any standard
electrical outlet.
WARNING! Only the charger
F000624017 has the selective key I for input
voltage. Always be certain that voltage
selection in the key is appropriate for your
power source voltage.
WARNING! Unplug the charger from
the tool after charging period has ended
thereby lengthening the service life of the
battery. Unplug charger from power
source before cleaning.
IMPORTANT:
While charging, the charger and the battery
may become warm to touch, this is normal
and does not indicate a problem.
Do not charge at temperatures below 0° C
and over 40° C.
Do not remove battery from tool while it is
running.
When you charge the battery for the first
time, it only accepts 80% of its maximum
capacity; after several charges and
discharges, however, the batteries should
be at full capacity and deliver maximum
performance
Do not repeatedly recharge the battery after
only a few minutes of operation; this may
result in a reduction of operating time and
battery efficiency.
The nickel-cadmium battery must be kept
separate from the natural environment and
should not be disposed of as normal
domestic waste.
Prior to disposal protect battery
terminals with heavy tape to prevent
short-circuit.
If you anticipate long periods of non-use for
the tool, it is best to unplug the charger from
its power source.
Inserting the accessory
§ Before any work on the machine itself,
remove the battery.
Screwdriving
Insert the bit G into the tool holder A or
To Next Page
Loading...
Need help?
General
