Skil 2000 User Manual

15
d) When battery pack is not in use, keep it
away from other metal objects like paper
clips, coins, keys, nails, screws, or other
small metal objects that can make a
connection from one terminal to another.
Shorting the battery terminals together may
cause burns or a fire.
e) Under abusive conditions, liquid may
be ejected from the battery; avoid
contact. If contact accidentally occurs,
flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid
ejected from the battery may cause irritation
or burns.
f) Do not use the screwdriver while being
charged. It has risk of overload in the
porter.
6. Service
a) Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
Safety instructions for cordless
drill/drivers
§ Read and save this instruction manual.
§ Wear ear protectors with impact drills
(exposure to noise can cause hearing
loss).
§ Use auxiliary handles supplied with
the tool (loss of control can cause
personal injury).
§ Avoid damage that can be caused by
screws, nails and other elements in your
workpiece, remove them before you start
working.
§ Always check that the supply voltage is
the same as the voltage indicated on the
nameplate of the charger (chargers with a
rating of 230V or 240V can also be
connected to a 220V supply)
§ Check voltage indicated on nameplate of
tool/charger/battery.
§ In case of electrical or mechanical
malfunction, immediately switch off the
tool or unplug charger from power
source.
§ SKIL can assure flawless functioning of
the tool only when original accessories
are used.
§ Before using accessories always
compare the maximum allowed r.p.m. of
that specific accessory with the r.p.m. of
the tool.
§ This tool should not be used by people
under the age of 16 years.
§ Be careful not to drill or drive into areas
where electrical wires may be contacted.
§ Do not activate switch when changing
accessories or carrying the tool.
§ Ensure that switch is in the middle
(locking) position before making any
adjustments or changing accessories as
well as when carrying or storing the tool
CHARGING/BATTERIES
§ Charge battery only with the charger that
is supplied with the tool.
§ Do not touch the contacts in the charger.
§ Do not expose tool/charger/battery to
rain.
§ Never charge battery outdoors.
§ Store tool/charger/battery in locations
where temperature will not exceed 40 °C
or drop below 0 °C.
§ Batteries will explode in fire, so do not
burn battery for any reason.
§ When damaged, and under extreme
usage and temperature conditions,
batteries may start to leak.
- If liquid comes into contact with the skin,
wash quickly with soap and water, then
with lemon juice or vinegar.
- If liquid gets into the eyes, flush eyes
with clean water for a minimum of 10
minutes and seek immediately medical
attention.
§ When battery is not in tool or charger, it
should be kept away from metal objects
such as nails, screws, keys etc. prevent
short-circuit.
§ Do not use charger when damaged, take
it to one of the officially registered SKIL
Service Stations for a safety check.
§ Do not use charger when cord or plug is
damaged, cord plug should be replaced
immediately at one of the officially
registered SKIL Service Stations.
§ Do not disassemble charger or battery.
§ Do not attempt to recharge non-
rechargeable batteries with the charger.

Skil 2000 Specifications

General

Brand	Skil
Model	2000
Category	Power Screwdriver
Language	English