What to do if my Skil 3550 will not start?
If your Skil Saw won't start, first ensure the power cord is properly plugged in. If it is, check your fuse or circuit breaker and replace the fuse or reset the breaker if needed. If the issue persists, the cord or switch may be damaged. In this case, have the cord or switch replaced by an Authorized Skil Service Center or Service Station.
Why my Skil 3550 does not come up to speed?
If your Skil Saw doesn't come up to full speed, the extension cord might be too light or too long. Replace it with an adequate cord. Another potential cause is low house voltage; if you suspect this, contact your electric company.
What to do if my Skil Saw has excessive vibration?
Excessive vibration in your Skil Saw can be caused by a tile blade that is out of balance. If this is the case, discard the tile blade and use a different one. Also, check if the tile blade bolt is not tight.
Why my Skil 3550 has excessive water?
Excessive water when using your Skil Saw can be due to a worn-out felt near the blade or worn-out rubber on the top guard. Replace the felt or the rubber/top guard to resolve this issue.
Covers safe practices for the work environment and electrical connections.
Guidelines for operator's physical safety during use.
Proper methods and precautions for using and maintaining the tool.
Specific safety guidelines tailored for tile saw operation.
Precautions for safe operation, blade handling, and material feed.
Warns about chemical exposure from dust and recommended protective measures.
Emphasizes constant vigilance and common sense for safe operation.
Summarizes key safety alerts found directly on the tool itself.
Guidelines for selecting and using appropriate extension cords.
Lists all included components and required assembly tools.
Lists technical details and performance ratings of the tile saw.
Procedures for safely removing and installing the tile saw blade.
Instructions for mounting and aligning the protective top guard.
Steps to attach and position the side extension for work support.
Recommendations for selecting a safe and suitable place to operate the saw.
Instructions on how to properly fill and manage the water reservoir.
Procedures for safely turning the tile saw on and off.
Step-by-step guide for performing straight cuts on tiles.
Instructions for making angled cuts on tiles using the miter guide.
Guide for performing angled cuts (bevels) on tiles.
Recommended procedures for cleaning and storing the saw after operation.
Common problems and their solutions for the tile saw.
To Next Page
General
