Lift top grille upwards and fix with prop. The prop is found within it’s housing, in front of condenser
grille. The images below demonstrate how the grill should be supported during maintenance.
Using the included brush, gently clean the condenser coil, maintaining caution.
As shown the picture above, condenser is located at the top of the unit. A ladder is required to
access to the top of the unit. On the top of the unit there is a cover which can be removed by a
screw driver or a hand drill. Once, open up the top cover, brush the condenser and reassemble
the cover.
Over time, dust may accumulate within the condenser that cannot be removed with a brush. If
this occurs, contact SKIPIO to arrange for a SKIPIO authorized service agent to clean the
condenser with compressed air.
To Next Page
Loading...
