Skipper CU-M001-SA - Page 21

2017-05-23
Page 21 of 40
CU-M001 User manual
The “Cong” page is used to enter all set up functions.
RUNTIME SCREEN SETUP - Programing of page A-D setup.
CALIBRATION - Calibration of speed, offset, tilt and temperature
ALERT SETUP - High speed and low speed alert setup.
DIAGNOSTICS - Diagnostics of DL2 system.
CU-M001 SETUP - Display communication setup. *
JB70 SETUP - Electronic unit communication setup. *
DL2 SETUP - DL2 sensor vessel specic setup.*
COMMUNICATION SETUP - Setup of NMEA input/Output. *
AUX SETUP - Setup of AUX input/output. *
To return back to “page A-D” from “Cong” press ‘BACK’ which is in the top left.
Coguration screens marked * are Password protected. Please see “Installation manual” for more
details.
If communication with JB70 Electronic unit is not possible from display unit the communicatiuon
may be reestablished by use of SKIPPER service software.
See the “Installation manual” for more details.
Pressing q will uncover more setups: