When the alert symbol is present pressing it will show a table of alerts. These can be acknowledged.
Current causes for system alerts are:
- No communication with electronic unit
The screen will show: “No communication” (the all data will be -.- and the time will not be present,
but the ‘:’ will be ashing). The time will dissapear, but the : will continue to ash
-No communication with the sensor (the speed, Depth and temp data will be -.- but other functions
will work.
- Bad data from sensor (Check the diagnostics menu)
- Other internal error detected (Check the diagnostic menu)
Alerts can be set for high speed and low speed, If in use, they should be made accessible as
informations on the right hand side. In this case they can be changed by pressing the information
for 2 seconds. Alerts can also be set and adjusted in the Alert menu page
To Next Page
Loading...