STEP 1
STEP 1 - SETUP
STEP 3 - ADJUSTMENT
STEP 2 - FEEDBACK
STEP 2
STEP 4
STEP 3
Connect by inserting the arm
assembly into the ground stake.
Select the desired height of the
arm assembly by using the push
button adjustments.
Position your club behind
the ball, keeping the arm
perpendicular to your body
and “target” line.
If you’re hitting an iron or
wedge, the ball should be just
above the ground and the
push button should be set on
the lowest hole.
If you’re hitting a wood
or driver, the ball should
be positioned such that
1/2 to 1/3 of it stays above
the top of your club. The push
button should be set on the
middle or top hole.
If you observe the ball moving too far left or right, you can work on changing your swing path into the ball to straighten out
your shot. Once you start hitting the ball consistently straight, the Pure Path will groove this feel into your normal swing.
Take your normal swing, and
then observe the path the
ball takes as it spins. The ball
will reset itself in position for
your next swing.
Iron or wedge
Slice / Pull
Wood or driver
Straight
Wood or driver
Hook / Push
Once the arm assembly is at
the desired height, secure
it in place by tightening the
black knob.
For the desired height,
make sure the ball hangs
straight down from the arm
assembly and spins freely.
It should never rest on the
ground or you will not be
able to observe how the
ball rotates.
Push assembled Pure Path
into the ground until the
stake is fully inserted.
USAGE INSTRUCTION
ASSEMBLY
Only use the Pure Path in open areas where you wouldn’t be hitting toward any people, animals, or objects.
Never swing a golf club when anyone is in front of or behind you.
The Pure Path is a very simple and effective training tool to help golfers learn to hit “pure” shots consistently. By observing the direct result of your ball striking,
you can work on making the necessary adjustments to create a swing path that results in balls that fly straight on the golf course.
CORRECT INCORRECT
To Previous Page
Loading...
