Skoda 2009 Yeti - Page 78

Seats and Stowage 77
Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data
Adjust the angle of the seat
– Press the switch at the front ⇒ page 76, fig. 77 or at the back
⇒ page 76, fig. 77.
Adjusting the seat backrest
– Press the switch ⇒ page 76, fig. 76 in the direction of the desired
setting.
Adjusting lumbar support
– Press the switch front ⇒ page 76, fig. 76 in order to enlarge the
curvature of the lumbar support.
– Press the switch rear in order to reduce the curvature of the lumbar
support.
– Press the switch top in order to adjust the curvature of the lumbar
support higher.
– Press the switch bottom in order to adjust the curvature of the
lumbar support lower.
Switch is operated in order to move the seat up/down and forward/back, while
switch is operated in order to move the backrest forward or back.
WARNING
• Only adjust the driver seat when the vehicle is stationary - risk of injury!
• Caution when adjusting the seat! You may suffer injuries or bruises as a
result of adjusting the seat without paying proper attention.
• In view of the fact that the seats can also be adjusted when the ignition is
switched off (even when ignition key withdrawn), you should never leave
children unattended in the vehicle.
• The seat backrests must not be angled too far back when driving other-
wise this will affect proper operation of the seat belts and of the airbag
system - risk of injury!
Note
If the movement of the seat is inadvertently interrupted during an adjustment, once
again press the switch in the appropriate direction and continue with the adjust-
ment of the seat to the end.
Storing setting
Storing seat and exterior mirror settings for driving forward
– Switch on the ignition.
– Adjust the seat ⇒ page 76.
– Adjust both exterior mirrors ⇒ page 73.
–Press button SET ⇒ fig. 78.
– Press one of the memory buttons within 10 seconds after pressing
the button SET - an acknowledgement signal confirms that the seat
setting is stored..
Storing exterior mirror setting for reversing*
– Switch on the ignition.
– Turn the exterior mirror control to position
 ⇒ page 73.
A
B
A
2
A
3
A
C
A
A
A
A
A
A
A
A
A
B
A
C
Fig. 78 Driver seat: Memory
buttons and SET button
A
A
A
B
s2ak.b.book Page 77 Monday, April 6, 2009 2:13 PM