Seats and Stowage76
– Lower the seat if required by pushing or pumping lever down-
wards.
Adjust the angle of the seat backrest
– Relieve any pressure on the seat backrest (do not lean on it) and turn
the handwheel ⇒ page 75, fig. 75 to adjust the desired angle of the
backrest.
Adjusting lumbar support*
– Pull on the lever until you have set the most comfortable curvature
of the seat upholstery in the area of your spine.
The driver's seat should be adjusted in such a way that the pedals can be fully
pressed to the floor with slightly bent legs.
The seat backrest on the driver's seat should be adjusted in such a way that the
upper point of the steering wheel can be easily reached with slightly bent arms.
WARNING
• Only adjust the driver seat when the vehicle is stationary - risk of injury!
• Take care when adjusting the seat! Adjusting the seat without care can
lead to bruises or injuries.
• The seat backrests must not be angled too far back when driving other-
wise this will affect proper operation of the seat belts and of the airbag
system - risk of injury!
Adjusting front seats electrically*
Adjusting seats
Adopt the correct seated position before setting ⇒ page 75.
Adjusting a seat in a forward/back direction
– Press the switch ⇒ fig. 76 forwards or backwards ⇒ fig. 77.
Set the height of the seat
– Press the switch ⇒ fig. 76 upwards or downwards.
To Next Page
Loading...
