Reducing or increasing the curvature of the lumbar support
›
Push the switch
A
in the region of one of the arrows 2 » Fig. 49.
Raising or lowering the curvature of the lumbar support
›
Push the switch
A
in the region of one of the arrows 1 » Fig. 49.
The adjusted driver's seat position can be set in the memory of the
seat » page 70 or the remote control key » page 70.
Note
If the setting procedure is interrupted, you will need to press the button again.
Head restraints
Fig. 51
Head restraint: front/rear
First read and observe the introductory information and safety warn-
ings on page 67.
Best protection is achieved if the top edge of the head restraint is at the same
level as the upper part of the head.
Setting height
›
Hold the front head restraints on the sides with both hands, press and hold the
safety button
A
» Fig. 51 and move the head restraints into position.
›
Hold the rear head restraints on the sides with both hands and move them up-
wards » Fig. 51.
To move the head restraint downwards, press and hold the safety button
1
with
one hand and press the head restraint downwards with the other hand.
The head restraints and the front seats must be adjusted to match the body size
at all times and the seat belt must always be fastened properly to provide the
most effective levels of protection to the passengers » page 172, Correct seated
position.
Removing/installing
Only the real head restraints may be removed.
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of arrow
1
» Fig. 51, simultaneously
press the locking button into the opening
2
using a flat screwdriver with a
width of maximum 5 mm and pull out the head restraint.
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
WARNING
■
The head restraints must be correctly adjusted in order to offer effective
protection for the occupants in the event of an accident.
■
Never drive with the head restraints removed - risk of injury.
■
If the rear seats are occupied, the respective rear head restraint must not be
in the lower position.
Note
■
For the sports seats, the head restraints are integrated into the front seat
backrests. These headrests cannot be adjusted by height or removed.
■
The middle rear head restraint is only adjustable in two positions.
69
Seats and useful equipment
To Next Page
Loading...
