The maximum permissible load of the variable loading floor is 75 kg. For the
transport of heavy loads, adjust the variable loading floor in the lower position
» Fig. 126.
Set into the lower position
›
Check that the area below the variable loading floor is empty.
›
Lift the variable loading floor by the handle
A
» Fig. 126 above the loading
edge in the direction of arrow
2
.
›
Pull the loading floor towards you in the direction of arrow
3
until it sinks to
the bottom position, and push forward.
Fold together / fold out the variable loading floor
Fig. 127
Fold up variable loading floor / folded variable cargo floor in the
upper position
›
To fold together, hold the variable loading floor by the handle
A
and lift in
the direction of arrow
1
» Fig. 127.
›
Fold up the variable loading floor by moving it in the direction of the arrow
2
.
Folding out takes place in reverse order.
The variable loading floor is folded together / out in the same way in the upper
and lower position.
Dividing the luggage compartment
Fig. 128
Dividing the boot with variable
loading floor
›
To divide, lift the variable loading floor by the handle
A
and push in the rear
edge of the variable loading floor in the grooves
B
in the direction of the ar-
row » Fig. 128.
The variable loading floor is secured against movements in the grooves
B
.
Folding out takes place in reverse order.
The variable loading floor is divided in the same way in the upper and lower po-
sition.
Net partition
Introduction
Using the net partition
Fig. 129
Open part of the roll-up luggage compartment cover / release
lever
104
Operation
To Next Page
Loading...
