Map alignment
Fig. 214
Map centring
The moved map can be centred/aligned to the vehicle, destination or route po-
sition.
On the map within function surface
A
» Fig. 214, the following symbols are
displayed, depending on the map display.
Aligning to the vehicle position (in the 2D or 3D map display)
Alignment to the destination position (in the destination position dis-
play)
Centring and displaying the entire route (in the route display)
Options for map display in the split screen
Only valid for Infotainment Columbus.
Fig. 215 Map in split screen
›
In the split screen, tap on function surface
A
» Fig. 215.
Depending on the context, some of the following function surfaces will be dis-
played in area
B
.
Map display with the route from the current vehicle location to the desti-
nation
Change the map orientation
1)
2D - Two-dimensional map display
3D - Three-dimensional map display
Switch on/off the automatic change of scale
Road sign display
Infotainment offers the option of displaying the traffic signs stored in the navi-
gation data or detected by the front camera during guidance on the Infotain-
ment screen
G
» Fig. 196 on page 175.
›
To switch on/off the road sign display in the main menu Navigation, tap on
the function surface
→
Map
→
Show road signs
.
For some vehicles it is possible to set an alert when exceeding the permitted
speed limited set by a road sign.
›
Press the
button, then tap on function surface
→
Driver assistance
→
Speed warning:
.
For trailer towing, we recommend that you activate recognition of road signs
relevant to trailers.
›
Press the
button, then tap on function surface
→
Driver assistance
→
Show road signs relevant to trailers
.
Route guidance
Introduction to the subject
A route is created by starting route guidance to a destination. Additional inter-
mediate destinations can be added to the route.
1)
The letter inside the symbol is dependent on the chosen Infotainment language.
186
Infotainment
To Next Page
Loading...
