CAUTION
To establish the connection, the date and time in the Infotainment system
must be set correctly. If the date and time setting is based on the GPS signal,
then problems may arise with establishing a connection when the GPS signal
reception is poor.
Note
■
During the connection process, information messages may be displayed on
the Infotainment screen, and in the phone display. These messages must be
observed and confirmed if necessary (e.g. release of data transfer, enabling the
import of contacts, release of text messages).
■
We recommend that you use extension cables from ŠKODA Original Acces-
sories.
■
With some connected external devices, is necessary for the connected ex-
ternal device to be “unlocked” for the entire duration of the connection to en-
sure trouble-free functioning of the SmartLink function.
Main menu
Fig. 158
Main menu: no connection/example of an active connection
›
To display the main SmartLink menu, press button
, then tap the function
surface .
›
or: tap on the function surface
(applies to the Infotainment Swing).
Main menu
Function surfaces » Fig. 158
Available communications systems
Active connection
Display of information about SmartLink
A
B
Disconnection of the active connection
Settings of the SmartLink » page 109 menu or » page 114
Connection set-up
▶
Connect the external device to the USB port using a connecting cable
» page 77.
▶
In the main SmartLink menu, select the type of communication system
A
» Fig. 158 or the connected external device
B
» Fig. 158.
Disconnection of the active connection
▶
To end the connection, go to the main SmartLink menu and tap on the func-
tion surface .
▶
or: Disconnect the cable from the USB port.
If the connection was ended by tapping on the function surface , then it is
necessary to establish the connection again when the external device is con-
nected again.
Android Auto
Introduction to the subject
The Android Auto connection can be set up under the following conditions.
The ignition is switched on.
Infotainment is switched on.
The external device to be connected is switched on.
Some applications require the data connection in the connected external de-
vice to be switched on.
If the Infotainment system is connected to an external device via Android Auto
then all the telephones currently connected, as well as the Bluetooth
®
players,
will be disconnected.
The external device to be connected will automatically establish a telephone
connection via Bluetooth
®
as a main phone.
It is not possible to connect an additional telephone for the duration of the
connection.
An external device connected using Android Auto cannot be used as an audio
source in the Media menu.
141
SmartLink+
To Next Page
Loading...
