Set-up menu
• by depressing the TP button for a few
moments, you can leave the set-up
menu without storing this change.
LOUD
The human ear cannot hear extremely
high or low frequencies as well as the fre-
quencies in the middle of the hearing
range.
The loudness function raises the volume
of the lower and higher frequencies some-
what to balance out this weakness, espe-
cially when listening to quieter music.
• Select LOUD in the menu. The display
shows "LOUD” with the current value.
• Use the turning knob to set the
loudness function (ON) or (OFF).
• By briefly pressing the TP button or
the rocker button , you can store
the indicated value and go to the next
menu point
or
• by depressing the TP button for a few
moments, you can leave the set-up
menu without storing this change.
MONO
This menu point is for changing your
appliance to mono operation. The change-
over to mono operation can improve the
reception quality, especially in bad
weather.
• Select MONO in the menu. The display
shows "MONO ”with the current value.
• Use the turning knob to set the com-
pulsory mono operation (ON) or (OFF).
• By briefly pressing the TP button or
the rocker button , you can store
the indicated value and go to the next
menu point
or
• by depressing theTP button for a few
moments, you can leave the set-up
menu without storing this change.
LOC
This menu point is for deciding whether
the search function should only seek
strong reception stations (LOC ON ) or if
weak reception stations (LOC OFF)
should be taken into account too.
• Select LOC in the menu. The display
shows "LOC” with the current value.
• Use the turning knob to set ON or OFF.
By briefly pressing the TP button or
the rocker button , you can store
the indicated value and go to the next
menu point
or
• by depressing the TP button for a few
moments, you can leave the set-up
menu without storing this change.
The radio appliance leaves the set-up
menu after 30 sec. if no changes have
been made over this time.
16
To Next Page
Loading...
