What causes warm cabinet temperatures in Skope Chiller?
Warm cabinet temperatures in your Skope Chiller, along with the compressor operating for long periods, can be caused by a blocked condenser or poor ventilation around the refrigeration unit. Clean the condenser filter and condenser, and ensure the cabinet has good ventilation. Also, make sure the cabinet is within its maximum operating temperature.
What causes a frozen evaporator coil in my Skope Chiller?
A frozen evaporator coil in your Skope Chiller can result from several issues: the set-point being too cold, a fault with the control or evaporator probe, a controller fault, a shortage of refrigerant, or a compressor pumping fault. Check and raise the set-point if it's too low. Check and replace the control probe or evaporator probe if faulty. Replace the controller if it's faulty. Perform refrigeration system diagnostics and service as required if there is a refrigerant shortage. Check the compressor and replace if necessary if there is a compressor pumping fault.
Lists SKOPE TME and SKT ActiveCore top mount chiller models and their types.
Details the CAREL S4 controller's functions, modes, and automatic cycles.
Explains the symbols and functions of the controller's display and buttons.
Describes Normal and Energy Saving modes and automatic switching.
Explains how the automatic defrost cycle is initiated and terminated.
Lists and explains controller display messages and active alarms.
Covers No-Downward Tendency, High Pressure, and Cold Climate protection.
Details controller hardware inputs, probe connections, and wiring termination.
Guides on adjusting temperature setpoints and controller parameters.
Instructions to access locked parameters and check parameter history.
Provides the electrical wiring diagram for the TME650 Series.
Provides the electrical wiring diagram for the TME1000 Series.
Provides the electrical wiring diagram for the SKT650 Series.
Provides the electrical wiring diagram for the SKT1000 Series.
Provides electrical wiring diagrams for TME1500 and SKT1500 Series.
Exploded views and part lists for TME/SKT 650, 1000, and 1500 series cabinets.
Exploded views and part lists for glass and solid door assemblies.
Exploded views and part lists for modular and LED lighting systems.
Exploded views and part lists for UTHCCI-0002, UTHCCI-0004, and UTSCCR-0001 units.
Exploded view and part list for the unit electrics box assembly.
Guidance on selecting optimal location, leveling, and space requirements.
Specifies the operating environment and temperature/humidity conditions.
Details factors for choosing the best chiller location for performance.
Information on the power cord exit and routing.
Details minimum clearance requirements for efficient operation.
Instructions for replacing LED tube and modular lighting components.
Procedures for aligning, adjusting, and removing/refitting doors and hinges.
Step-by-step guide to reverse door hinging from RH to LH.
Procedures for removing, replacing, and servicing the refrigeration unit.
Guides for replacing condenser and evaporator fan motors and blades.
Steps for replacing the compressor, its electrics, and related components.
Instructions for replacing control probe, evaporator probe, door switch, and pressure switch.
Procedures for cleaning the cabinet, condenser coil, and optional filter.
Details controller alarms, their causes, and recommended repairs.
Troubleshooting common problems related to cabinet and refrigeration unit.
To Next Page
General
