SKS Germany COMPIT - Task and Function; Compit; Compit+ & +Com;Charger; Compit Stem

COMPIT
26
Task and function
COMPIT
The COMPIT is used for mounting a smartphone on the handlebar of a bike. To do this, the mobile
phone must be equipped with a special COMPIT COVER. The docking station allows the smartphone to
be mounted horizontally and vertically with a single twist. The tilt adjustment allows the mobile phone
to be moved to the desired position. The COM/LIGHT adapter for mounting the front lamp (lamp not
included) and the COM/CAM adapter (not included) for mounting a camera can also be affixed to the
COMPIT.
COMPIT
+
and
+
COM/CHARGER
The
+
COM/CHARGER is additionally included in the scope of delivery for the COMPIT
+
/POWER. The
+
COM/CHARGER is used to charge and connect the smartphone while cycling. This can be affixed
to the COMPIT. Smartphones that have a wireless charging function are charged by affixing the
smartphone to the Qi docking station. Smartphones without a Qi charging function can be charged
with an optional USB cable. It is affixed using a cover not included in the scope of delivery. The tilt
adjustment allows the
+
COM/CHARGER to be moved to the desired position. The
+
COM/CHARGER
can be charged with the USB cable included in the scope of delivery.
1x
➤Device on
2x
➤Device off
stanby after 10 minutes
COMPIT/STEM
The COMPIT/STEM mobile phone holder consists of a bayonet mount and the stem mounting. The
phone holder is mounted below the ahead cap on the handlebar stem. The holder can be mounted
in two directions, so that the mobile phone does not touch your knees even when riding out of the
saddle.
COMPIT SPACER
The COMPIT SPACER accessories allow for stem widths or on-board computers up to a maximum
width of 80 mm to be covered. These include on-board computers from Bosch, Yamaha and Shimano.