Wireless Earphone
MODEL: S2JPW
Skullcandy and other marks are registered trademarks of Skullcandy, Inc. All rights reserved.
Speaker Driver. 9mm
Impedance: 16 Ohms
THD <3%@1 khz
Voltage Regulation: 3.7v
Bluetooth 5.0
Weight 17g.
Hardware: V3.0
Software: V2.0
Bluetooth function: 2402MHz-2480MHz54dBm
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, them is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or mom of the following measures:
— Reorient or relocate the receiving antenna. — Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
To Next Page
Loading...
