Sky Climber Compact 1250 - EQUIPMENT CHECKLISTS; Daily Rigging Component Checklists

January 2019 Page 28
CHECKLISTS
CHECK DAILY or before the start of each shift:
Cornice Hook
 Substantial structure for hook and tieback point
 Tieback at proper angle
 Check fist grip torque (5/16” – 30 ft. lbs.; 3/8” – 45 ft. lbs.)
 Bearing block in place
 Warning and rating labels in place and legible
 Capacity equal to or greater than hoist rated working load
 Spacing of hooks equal to hoist spacing
Parapet Clamp
 Substantial structure for clamp and tieback
 Wall surfaces parallel (vertical)
 Tieback at proper angle
 Check fist grip torque (5/16” – 30 ft. lbs.; 3/8” – 45 ft. lbs.)
 Warning and rating labels in place and legible
 Capacity equal to or greater than hoist rated working load
 Spacing of clamps equal to hoist spacing
Rolling Roof Rigs
 Tieback at proper angle to substantial structure
 Check fist grip torque (5/16” – 30 ft. lbs.; 3/8” – 45 ft. lbs.)
 Load on jacks – not casters
 All hardware in place and properly torque
 Warning and Rating labels in place and legible
 Counterweights – correct amount, properly attached
 Beam reach limit not exceeded for hoist rating
 Spacing of beams equal to hoist spacing
Tank Top
 Tieback to substantial structure
 Check fist grip torque (5/16” – 30 ft. lbs.; 3/8” – 45 ft. lbs.)
 Make sure roller is seated properly
 Warning and Rating labels in place and legible
 Make sure roller rating is equal to or greater than hoist capacity
Ring Girder Roller
 Tieback to substantial structure
 Check fist grip torque (5/16” – 30 ft. lbs.; 3/8” – 45 ft. lbs.)
 Make sure roller is seated properly
 Warning and Rating labels in place and legible
 Make sure roller rating is equal to or greater than hoist capacity
Rigging Slings
 Make sure sling is attached to a substantial structure (4:1 Safety Factor)
 Check fist grip torque (5/16” – 30 ft. lbs.; 3/8” – 45 ft. lbs.)
 Make sure rope is protected at chafing points
 Make sure rope is protected at break points