ESPT FR EN
1.
2.
2.
3.
1.
2.
3.
Program menu for VARIO board
Entering menu
Automatic on
opening
Automatic on
opening/closing
Dead man
Exiting menu
NOTE:
NOTE:
NOTE:
Press for 5 seconds. The display will show
Enter the function the display will show which corresponds to the automatic on opening program.
Press again to enter the desired function.
Press to save the chosen parameters and exit the menu.
Press to record the selected program and return to menu. The display will show
The display will show the position of the gate with the chosen operation program.
In any of the programming modes, the STOP button always stops the gate.
When closed - Open;
When closed - Open;
Select the program
Select the program
Select the program
a)
a)
a)
b)
b)
b)
The opening is executed in automatic
mode (press the ‘up’ button once) and
the descent is in dead man mode (keep
the ‘down’ button pressed).
The opening and closing are executed
in automatic mode (press the ‘up’ or
‘down’ button once).
The opening and closing are executed
in dead man mode (keep the ‘up’ or
‘down’ button pressed).
While opening - Stop;
While opening - Close;
While opening - Stop;
While opening - Null;
While opening - Null;
When closed - Open;
When open - Close.
When open - Close;
While closing - Null.
When open - Close.
While closing - Open.
While closing- Open.
While closing - Stop.
If you have auto-close active (see related topic). Closes after the set time.
(open) (half-open) (closed) (program chosen for operating the door)
Use the buttons or o navigate through the menu’s functions.
Use the buttons or to navigate through the available programs.
Use the buttons or to go to the function 6.
P
P
P
P
+
+
+
-
-
-
Programming functions
1.
and
(example)
4.
Press to save the function and return to the menu.
P
To Next Page
Loading...