1 1. Tro ub le Shooting
connected securely by
2. Replace with a new fuse of
referring t o 8 on P 13.
of t he same type .
of the s ame type .
photocell sensor is not shielded.
2. Set the operating time referring
to (9) on P16.
referring to (5) on P 15.
to the wiring diagram on P 12
.
Troubl es
Causes
Soluti ons
The g ear m ot or
do es n' t work.
1. The plug is not securely
connected.
2. The fuse on the pcb is
blown.
The gearmotor doesn't
work when operating
the transmitter.
1. The transmitter has not
been memorized.
2. The battery of the
transmitter has not
enough power.
3. The clutch is dis-engaged.
1. Memori ze the transmitter
The trans mitter
distance is s hort .
The battery of the
transmitter has not enough
power after long time use.
Replace with a new bat tery
The moving speed of
the gate leaf is slow.
1. The installation of the gate is
not proper, so the moving
become not smooth .
2. The moving speed of the
gearmotor is not adjusted
properly.
1. Release the gearmotor and
move the gate leaf by hand
to see if it can move smoothly.
2. Set the moving speed referring
to (8) on P 15 .
The gate leaf can not
open or close completely
or it does not move .
1. The photocell sensor is
shielded.
2. The operating time of the
gearmotor is not adjusted
properly.
1. Check and make sure the
The gate leaf can not
close automatically .
1. The auto closing function
is set OFF .
2. The wire connection of the
unit is not correct .
1. Set the auto closing time
2. Connect the wire refer ring
2.Replace with a new battery
3.Eng age the clutch
with the release key .
1 2. Rec ycl ing a nd Ma nipu lation
Ther e are differ ent k ind s of m at eri al in a sw ing g ate o pener . So me can be
recyclabl e, s uch as alu mini um , iron, plastic , w ires etc., bu t som e of the m
can' t.
Warning : Lead-ac id backup battery and some electronic material are
harmful substanc es. In order not to get the environment polluted, they
should be recycled or disc arded acco rd ing to requirements of the l ocal
law regulation.
1 . Completel y cu t off the power supp ly.
2 . Di sassemble all the equipments and accessories.
3 . Take out the backup battery from the control box and th e battery
from transmi tters.
4 . Take out the PCB.
5. Re cycl ab le mat eri als s hould b e ha ndl ed b y t he loca l qualif ied com pany.
6 . Backup battery, battery from transmitter and control board, etc .
with harmful su bstances shoul d be h and led by the local quali fied
company so that they won't cau se any p olluti on to the environment.
To Previous Page
Loading...