Skybox 5500 Appliance 11
Chapter 3
This chapter explains how to set up Skybox 5500.
In this chapter
Installation ............................................................................................................... 11
System configuration ............................................................................................... 11
Installation
This section explains how to install the Skybox 5500 Appliance.
Starting Skybox 5500
To start Skybox 5500
1 Connect the AC power cords to the AC connectors on Skybox 5500’s back panel and connect the
other ends to a power supply.
Note: Skybox 5500 can be used with either 110 or 220 volt power.
2 On Skybox 5500’s front panel, press the power button.
3 Lock the front bezel in place using the key provided.
System configuration
Before running the Skybox View Server, configure the Skybox 5500 Appliance to be part of your
network and perform some initial system configuration.
Configuring connection
Before using the Skybox 5500 Web Administration, you must configure connection of Skybox 5500 to
your network. This configuration is done locally, using either:
• Mouse, keyboard and screen
• Serial port connection
Note: For a diagram of the connectors used in the following procedures, see Back panel connectors
(on page 10).
Setting up Skybox 5500
To Next Page
Loading...