HB600-24B CHARGER MANUAL 06JAN2009
- 9 –
Troubleshooting
Identify the problem from the following list and refer to the appropriate section for detailed
instructions.
1. CHARGER DOES NOT TURN ON.
2. 3 LED’s BLINK SIMULTANEOUSLY
3. 100% LED BLINKS WHILE 50% AND 75% LED'S ARE "OFF"
4. BATTERIES DO NOT FULLY CHARGE
5. THE AC SUPPLY CIRCUIT BREAKER OR FUSE IS BLOWN
1. CHARGER DOES NOT TURN ON.
Double check the outlet to ensure it is working by trying out another known good piece of
equipment on the outlet. Check the AC plug and wire to ensure both are in good condition.
Replace charger if everything else is correct.
2. 3 LEDS BLINK SIMULTANEOUSLY
The faults identified below cause the 3 LED’s to blink simultaneously and a buzzer to sound. If
the cause of the fault is removed the charger restarts automatically, the LEDs go into normal
operational mode, and the buzzer stops.
▶
3 LEDS BLINK ONCE SIMULTANEOUSLY : OUTPUT CONNECTION ERROR.
-> CHECK THE BATTERY AND CHARGER CONNECTION AND CORRECT
(The output may not be connected to the batteries or the connections to the batteries may
have corroded or loosened. The output may be shorted due to improper connection to the
batteries or pinched wires. The output may be connected in reverse polarity to the batteries.
The charger is not damaged by any of these problems.)
WARNING: Do not disassemble the charger. High voltages inside the charger
are an electric shock hazard and may result in serious injury or death.
WARNING: Do not operate the charger if it is malfunctioning. Personal injury
or property damage could result. Electric shock hazard may cause serious injury
or death.
CAUTION: If the AC plug or receptacle is broken, twisted, bent or loose, it cannot
make a good electrical connection and an electric shock hazard may exist. Have it
repaired or replaced by a qualified person immediately. DO NOT USE THE CHARGER
UNDER THIS CONDITION. Fire, injury, or death may result if not corrected.
To Next Page
Loading...
Need help?
General