SKYJACK, Page 15SJIII Series
Section 1 - Scheduled Maintenance Service and Maintenance
About this Section
This section contains the maintenance and inspection
schedule that is to be performed.
References are made to the procedures in Section 5
that outline detailed step-by-step instructions for checks
and replacements.
Service Bulletins
Before performing any scheduled maintenance
inspection procedure, refer to service bulletins found in
our web site: www.skyjackinc.com for updates related
to service and maintenance of this aerial platform.
Maintenance and Inspection
Death or injury can result if the aerial platform is not kept
in good working order. Inspection and maintenance
should be performed by competent personnel who
are trained and qualified on mantenance of this aerial
platform.
WARNING
Failure to perform each procedure as pre-
sented and scheduled may cause death,
serious injury or substantial damage.
NOTE
Preventive maintenance is the easiest and
least expensive type of maintenance.
• Unless otherwise specified, perform each
maintenance procedure with the aerial platform in
the following configuration:
- Aerial platform parked on a flat and level
surface
- Disconnect the battery by turning the main
power disconnect switch to the “OFF” position.
• Repairanydamagedormalfunctioncomponents
before operating aerial platform.
• Keeprecordsonallinspections.
Maintenance Instructions
This manual consists of four schedules to be done for
maintaining on an aerial platform. Inspection schedule
frequency is shown below:
Inspection Schedule
Daily A
Frequently A + B
Annually A + B + C
Bi-annually A + B + C + D
Make copies of the maintenance and inspection •
checklist to be used for each inspection.
• Checkthescheduleonthechecklistforthetypeof
inspection to be performed.
• Place acheckin the appropriate box after each
inspection procedure is completed.
• Usethemaintenanceandinspectionchecklistand
step-by-step procedures in Section 5 to perform
these inspections.
• Ifanyinspectionreceivesafail,tagandremovethe
aerial platform from service.
If any aerial platform component(s) has been •
repaired, an inspection must be performed again
before removing the tag. Place a check in the repair
column.
Legend
P = Pass
F = Fail
R = Repaired