Skyjack SJ86T User Manual

SJ 86T
December 2007 Page 31
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the MEWP.
FAMILIARIZATION
2.4 Function Tests
Function tests are designed to discover any malfunctions
before MEWP is put into service. The operator must
understand and follow step-by-step instructions to test
all MEWP functions.
IMPORTANT
Never use a malfunctioning MEWP. If
malfunctions are discovered, MEWP
must be tagged and taken out of service.
Repairs to MEWP may only be made by
competent/qualied repair personnel.
NOTE
To perform this function test, ensure there
is sufcient space to fully raise and extend
boom.
After repairs are completed, operator must perform a
pre-operation inspection and a series of function tests
again before putting MEWP into service.
Prior to performing function tests, be sure to read and
understand Section 3.7 - Start Operation.
NOTE
All-function motion alarm should sound
while operating any boom and drive
function.
2.4-1 Test Main Power Disconnect Switch
1. In engine compartment, turn main power
disconnect switch to “ ” off position.
Result: MEWP functions should not operate.
2. In engine compartment, turn main power
disconnect switch to “ ” on position.
NOTE
Close all cowlings before proceeding to
next item.
2.4-2 Base Control Console
1. On platform control console, pull out “ ”
emergency stop button.
2. On base control console, pull out “ ” emergency
stop button.
3. Turn off/base/platform key switch to “ ” base
position.
4. Start engine by selecting “ ” start position from
start/function enable/emergency power switch.
HOUR METER
QUARTZ
COUNTER
Base Control
Console
Off/Base/Platform Key
Switch
Emergency Stop
Start/Function Enable/
Emergency Power Switch
Section 2 - Familiarization Function Tests

Skyjack SJ86T Specifications

General

Brand	Skyjack
Model	SJ86T
Category	Boom Lifts
Language	English