Skyjack SJ86T - Refueling Procedure

Page 60 December 2007
SJ 86T
Refueling Procedure Section 3 - Operation
3.8 Refueling Procedure
This section provides the operator with the procedure
on how to refuel the engine.
WARNING
Failure to heed the following safety
precautions could result in death or
serious injury:
• Use extreme caution while refueling
MEWPs.
• Ensure that engine and all systems
are turned off before refueling.
• Refuel the MEWP only in a well
ventilated area away from open
ame and other sources of ignition,
authorized by your employer and
supervisor.
• Diesel engine models:
Use ultra low sulfur fuel only.
WARNING
Do not smoke in an area where MEWPs
are stored or refueled.
CAUTION
When operating on a slope, ensure fuel
level is above half to avoid a possible
stall condition.
IMPORTANT
Before using your MEWP ensure there is
enough fuel for expected use.
3.8-1 Refuelling (Gasoline or Diesel)
IMPORTANT
Use unleaded gasoline or ultra low sulfur
diesel as indicated on fuel tank.
1. Ensure engine and all systems are turned off and
emergency stop buttons are depressed.
2. Open control compartment and remove fuel cap.
3. Carefully ll the fuel tank ensuring that no spillage
occurs.
4. Secure fuel cap.
5. Ensure there are no leaks in fuel system.
6. Wipe up any spilled fuel.
7. Dispose of rags in an approved container.