SkyLink IQ SERIES User Manual

-17-
INSTALL SAFETY BEAM SENSOR
1
Mounting the Sensor on the Wall
(Optional)
3 1
Mounting the Sensor on the Floor
(Optional)
4
For wall mounting, use wood block to increase the
depth and have enough clearance for the sensor
beam to be unobstructed.
For floor mounting, use wood block to elevate the sensor
brackets if necessary. Ensure the sensor is no higher than
6” (15cm) above floor. Fasten the screws to the floor with
concrete anchors (Not Provided).
Wire Clip
Wood Block
Attach with concrete anchors
(Not provided)
Lag screws
Wire Holder
Red
White
1
Route & Secure the Sensor Wires
5
1
Connect the Wires to the Opener
6
Run the wires up the wall, then over to the center
of the door. Secure the wires to the wall with wire
holders. Run the wires along the top of the T-rail
and secure them with 4 wire clips provided.
Twist like colored wires together. Connect the wires to the “Safety Sensor” terminals.
Wires are not polarity sensitivity (either wire to either terminals)
C3x1
C2
Lag screws
C5x2
C5x2
C3C2
Actual Size
C5

SkyLink IQ SERIES Specifications

General

Brand	SkyLink
Model	IQ SERIES
Category	Garage Door Opener
Language	English